3D files included are those shown in screenshots.

PLEASE NOTE:

• Files are in OBJ format. (digital files only)

• Files have been tested in Cura and Chitubox

• Please scale the files to 1000% for printing (you can change this % depending on your height, but it will require different internal supports)

  • At 1000%, the largest file has a length of 39.3cm. Please make sure your printer has a build volume with at least 39.3cm in one dimension if you intend to print at this scale.

  • At this scale, you will need for internal support:

  • 1x cylindrical support (3mm diameter x 5cm length)

  • 1x cylindrical support (17mm diameter x 60cm length)

  • 2x cylindrical support (10mm diameter x 30cm length)

  • 2x cylindrical support (8.0mm diameter x 100cm length)

  • 1x cylindrical support (6.5mm diameter x 90cm length)

  • (Yes, there are a lot of internal supports!)

• Please also note that:

  • Patterns for the flowers/leaves/ribbons are not included.

  • The length of the blade is intended for you to fill it with clear resin.

• Files are personal use ONLY. You cannot resell or redistribute them.